Adhesives & Mortar Systems

KingPlast DC100^®

Single component colored stucco decorative wall finishing plaster.

⬇ Download TDS Request a Quote →

Working time

≈ 1.5 – 2 hrs

Maximum aggregate size

1 mm

Coverage

16 liters/ bag.

Packaging

Bag

Standards

1 cited

ASTM C109

Overview

KingPlast DC100 is a polymer modified cement decorative wall finishing stucco plaster applied in 2 – 3 mm thickness. KingPlast DC100 is supplied as a ready to use blend of dry powders which requires only the site addition of clean water to produce a consistent cementitious mortar.

Applications

KingPlast DC100 is designed as a decorative wall finishing plaster to be applied in 2 – 3 mm thickness on rendering and concrete walls to produce an artistic textured wall finish

Advantages

Shrinkage controlled polymer modified plaster
No independent primer necessary
Easy to apply, single component, requires only addition of water
Curing not generally required
Excellent bond to the substrate
Available in many colors

Technical Properties

Property	Value	Standard
Colour	Variable	—
Fresh wet density	1.90 ± 0.1 gm/ cm³	—
Working time	≈ 1.5 – 2 hrs	—
Compressive strength	(wet > 10 MPa @ 28 days cure) /109M-02	ASTM C109
Minimum application	5⁰C	—
temperature		—
Maximum aggregate size	1 mm	—
The following results were obtained at a water	powder ratio of 0.2 by weight. 5.0 – 5.5 liters of clean water should be added to clean container. The powder is then added slowly to the water while mixing continuously with low speed mixer/drill (400 - 600 rpm). Mixing time should be continued for 3 minutes until uniform consistency is obtained. Water addition may vary slightly according to both the ambient temperature and the desired consistency of the mix, but it should not exceed 5.5 liter.	—