KingFloor UN200^®

Concrete substrates should be fully cured and achieve a minimum compressive strength of 25 N/mm2 and a minimum pull-off strength of 1.5 N/mm2.

The concrete substrate should be below 75% RH and have less than 4% moisture content. Alternatively, KingFloor DPM should be used after consulting with KINGKRETE’s Technical Department.

Concrete surfaces must be degreased using degreasing products, torching or any other suitable method which assures the surface is free from any oil traces.

Concrete surfaces are to be mechanically prepared to remove laitance and achieve a flat surface, grit blasting or surface profiling equipment are preferred. Acid etching can be used after consulting with KINGKRETE's Technical Department.

Surface defects such as voids and blowholes should be repaired before application. Consult KINGKRETE's Technical Department for the best repair material.

Surfaces must be free of any dust or loose particles before product application. Use suitable methods like vacuuming or sweeping. If possible, apply the product on a small test area before actual application to check for any problems with the surface preparation.

If a primer is needed according to the system components section, KingFloor UN100 primer shall be applied using a brush, roller or squeegee to obtain a continuous primer coat. If needed, apply an additional coat of KingFloor UN100, and allow to dry before the primer is covered with other flooring systems. For further details, please refer to KingFloor UN100 technical data sheet.

Prior to mixing, stir individual components of KingFloor UN200. Add the KingFloor UN200 hardener to the base and using a jiffy-type mixer attached to a slow running electric drill, mix for approximately 2 minutes.

Once the KingFloor UN200 hardener and base have been mixed, transfer the entire contents into a Casco or Creteangle-type mixer, taking care to ensure that the bottom and sides are thoroughly scraped.

Start the mixer and transfer to it the entire contents of the KingFloor UN200 quartz sand and a suitable extender (fine filler) if necessary, taking care to ensure that these are completely dry and lump-free. Continue mixing for approximately 2 minutes.

Note: Never mix KingFloor UN200 by hand as this could lead to areas of uncured material.

A, B & C) Coatings

Apply KingFloor UN200 as coating using a roller or brush to the required thicknesses.

D & E) Self-leveling floor toppings

Pour the mixed material onto the primed surface and spread using a trowel or rake at the required thickness and allow to attain a smooth finish. While still wet, thoroughly spike roll KingFloor UN200 in two directions to help eliminate the entrapped air.

F) Broadcast system

Pour the mixed material of the medium thickness self- levelling floor topping onto the primed surface and spread using a trowel or rake at the required thickness and allow to attain a smooth finish.

While still wet, thoroughly spike roll KingFloor UN200 to help eliminate the entrapped air. While still wet, broadcast with Antislip Aggregate #2 or #3 to excess and wait until it gets dry, then remove excess aggregate. Apply KingFloor UN200 sealcoat with a roller at the required thickness.

KingFloor UN200 can be removed by KINGKRETE solvent prior setting.