KingPro DynaCrack1000®
Environmentally safe, non-explosive agent for controlled concrete demolition
SpecWorld has the Spec Pack, CSI specification and drawings for registered specifiers.
Overview
KingPro DynaCrack1000 This non - explosive demolition agent is a safe, environmentally friendly, and efficient solution for the controlled breaking of mass concrete, rock, walls, and piers. Designed to replace traditional demolition methods like blasting or heavy machinery, it enables precision work without noise, vibration, or pollution.
Where to use
- Demolition of mass concrete structures, walls, and piers.
- Controlled breaking of rocks in urban or sensitive environments.
- Excavation projects in noise-restricted areas (e.g., hospitals, schools).
- Situations where explosives are restricted or impractical.
- Removal of reinforced concrete with minimal damage to surrounding structures.
Why use it
- Non-Explosive: Eliminates risks associated with explosive materials.
- Low Pollution: Environmentally friendly with minimal dust, noise, and vibration.
- Safe and Easy to Use: No special licensing or permits required for handling.
- Controlled Results: Breaks materials in a predictable manner.
- Cost-Effective: Reduces labor and equipment costs compared to traditional methods.
Technical properties
| Property | Test results |
|---|---|
| Appearance | Gray Powder |
| Density | 2.0 g/cm³ |
| Water Requirement | 30–35% (by weight of powder) |
| Expansion Pressure | Up to 60 MPa |
| Initial Reaction Time | 30–60 minutes at 25°C |
| Full Expansion Time | 12–24 hours |
| Working Temperature Range | 5°C to 40°C |
| Toxicity | Non-toxic, no hazardous fumes |
PLACING AND FINISHING
Filling
- Pour the mixture into the pre-drilled holes. Do not overfill.
- Curing Time: Allow 12–24 hours for full expansion and cracking. The timing depends on temperature and material density.
Standards and approvals
KingPro DynaCrack1000 complies with EN 1504, Part 3, Class
How to use
Method of use
- Preparation: Ensure the area is clean and free from debris.
- Drilling: Drill holes in the target structure according to the pattern specified:
- Hole diameter: 30–40 mm
- Hole depth: 80–90% of the concrete/rock thickness
- Hole spacing: 20–40 cm, depending on the strength of the material.
Mixing
- Mix (product name) with clean water in a ratio of 30–35% by weight.
- Stir well to achieve a lump-free slurry.
Cleaning
All tools should be cleaned immediately after finishing using a suitable epoxy thinner. Hardened materials should be cleaned mechanically.
Limitations and notes
- If application is done under high temperatures (> 40°C), care should be done because the working time will be reduced significantly.
- To reduce the effect of this problem, try to store the unmixed materials in a cool environment, avoiding the direct sunlight. Also, try not to make the application in the middle of the day or direct sunlight.
Coverage, packaging and storage
Yield
Approximately 10 litre per 20 kg pack, 15 litre per 30 kg pack and 50 litre/100 kg pack.
Packaging
KingPro DynaCrack 1000 is available in 20 kg and 1 kg packs.
Storage
Shelf life is 1 year when stored under cover, out of direct sunlight and protected from extremes of temperature.
Failure to comply with the recommended storage conditions may result in premature deterioration of the product or packaging. For specific storage advice consult KingKrete's Technical Services Department.
HEALTH AND. SAFETY
As with all chemical products, care should be taken during use and storage to avoid contact with eyes, mouth, skin and foodstuffs. Treat splashes to eyes and skin immediately. If accidentally ingested, seek medical attention. Reseal containers after use. Use in well ventilated areas and avoid inhalation.