KingFiber PP50®
High performance monofilaments polypropylene macro fiber.
SpecWorld has the Spec Pack, CSI specification and drawings for registered specifiers.
Overview
KingFiber PP50 is a synthetic macro fiber manufactured of 100% polypropylene fibers containing no reprocessed olefin materials and with excellent alkali resistant, impermeable and non-corrosive properties.
The unique composition of KingFiber PP50 makes it an excellent alternative to the traditional reinforcement steel mesh in order to significantly reduce the plastic shrinkage cracking and enhance the durability and the mechanical properties of the cementitious mixes.
Where to use
KingFiber PP50 is ideally designed to decrease the plastic shrinkage cracking in the following applications:
- Slab on grade.
- Elevated slabs.
- Parking areas.
- Stamped concrete.
- Pre-cast concrete.
- Water tanks.
- Pavements.
- Shotcrete.
- Renders.
- Composite decks.
Why use it
- Controls and inhibits crack formulation caused by plastic shrinkage, settlement or other internal stresses in concrete.
- Cost effective, replaces secondary reinforcements steel mesh.
- High tensile strength.
- Easily distributed throughout the cementitious mix.
- Compatible with all types of cement and concrete admixtures.
- Rust free.
Technical properties
| Composition | 100% virgin polypropylene |
|---|---|
| Shape | Monofilaments macro fiber |
| Specific gravity | 0.95 ± 0.05 |
| Modulus of elasticity | 3.4 - 4.0 GPa |
| Absorption | Nil |
| Melting point | 160˚C |
| Ignition point | 580˚C |
| Chloride content | Nil |
| Sulphate content | Nil |
| Alkali content | Nil |
Standards and approvals
- KingFiber PP50 complies with the requirements of ASTM C1116, Type III.
- KingFiber PP50 complies with BS EN 14889-2 for structural use in concrete.
How to use
Mixing
KingFiber PP50 is added to the mixer before, during or after batching of concrete. The mixing time and speed should be as per ASTM C94. Before discharging the mixture, set the mixer at the maximum speed for 1 - 2 minutes to ensure uniform distribution.
DOSAGE
Dosage of KingFiber PP50 will vary depending on the area of application and the required properties of concrete mixes.
Typical dosage is between 1.0 - 5.0 kg/m³ of concrete.
Please contact KINGKRETE Technical Department for assistance in product optimization.
Coverage, packaging and storage
Packaging
KingFiber PP50 is available in 6 kg bags.
Storage
Shelf life is 1 year when stored under cover, out of direct sunlight and protected from extremes of temperature.
Failure to comply with the recommended storage conditions may result in premature deterioration of the product or packaging. For specific storage advice consult KingKrete's Technical Services Department.
Health and safety
As with all chemical products, care should be taken during use and storage to avoid contact with eyes, mouth, skin and foodstuffs. Treat splashes to eyes and skin immediately. If accidentally ingested, seek medical attention. Reseal containers after use. Use in well ventilated areas and avoid inhalation.