🌍 🌐 English
Adhesives, Mortars & Plasters

KingBond EP50®

One-part Low Modulus Neutral Cure Silicone Adhesive

SpecWorld has the Spec Pack, CSI specification and drawings for registered specifiers.

Overview

KingBond EP50 is a one-part, low modulus neutral cure silicone adhesive, which cures on exposure to moisture vapour to form an elastic silicone rubber.

Where to use

KingBond EP50 shows an excellent adhesive without primer to:

  • Glass.
  • Tiles.
  • Ceramics.
  • Aluminum.
  • Epoxy and polyester.

Why use it

  • Single component ready for use.
  • Excellent adhesion.
  • Priming is not required for most substrates.

Technical properties

Typical shore A
hardness
30
Application temperature5 - 50°C
Service temperature-50 -150°C
Skin time @ 20°C/
65% RH
5 mins.
Cure rate @ 20°C/
65% RH
2 mm/ 24 hrs.
Chemical resistanceResistant to most dilute
acids and alkalis; organic
solvents may cause the
sealant to swell and lose
adhesion, but do not
directly dissolve the
sealant
UV resistanceVery good
Service life25 years +
ColoursWhite, black, grey,
mahogany, translucent &
anthracite

How to use

Surface preparation

Surfaces must be clean, dry and free from all contamination. Primers may be required on some substrates. It is recommended that KingKrete Technical Services Department should be consulted and advice obtained with regard to the choice of primer for specific purposes.

Application

KingBond EP50 is supplied in cartridges and can be applied to the substrate using Caulking Gun.

Coverage, packaging and storage

Packaging

KingBond EP50 is available in 280 ml cartridges.

Storage

Shelf life is 1 year when stored under cover, out of direct sunlight and protected from extremes of temperature.

Failure to comply with the recommended storage conditions may result in premature deterioration of the product or packaging. For specific storage advice consult KingKrete's Technical Services Department.

Health and safety

As with all chemical products, care should be taken during use and storage to avoid contact with eyes, mouth, skin and foodstuffs. Treat splashes to eyes and skin immediately. If accidentally ingested, seek medical attention. Reseal containers after use. Use in well ventilated areas and avoid inhalation.

Request the safety data sheet