🌍 🌐 English
Adhesives, Mortars & Plasters

KingBond EP50PC®

Solvent free, two part epoxy adhesive for concrete surfaces.

SpecWorld has the Spec Pack, CSI specification and drawings for registered specifiers.

Overview

KingBond EP50PC is fast set, medium viscosity, solvent free, two part epoxy adhesive.

KingBond EP50PC is a two component product. Components are black and white in color, when mixed at 1:1 ratio turn into a uniform grey color paste that bonds to asphalt and concrete surfaces.

Where to use

KingBond EP50PC is a fast set, high strength adhesive primarily designed for bonding pre-cast segmental concrete units. It can be used as a general purpose fast set epoxy paste for filling gaps, holes and surface irregularities, and for bonding of steel elements and natural stone.

Why use it

  • Fast set.
  • Easy to use.
  • Rapid adhesive strength development.
  • High tensile and shear strength.
  • 1:1 mixing ratio, making mixing easy and minimizing waste.

Technical properties

Values @ 25°C

Bond strength to
concrete: ASHTO 237
Failure in concrete
Slant shear strength
ASHTO 237
Failure in concrete
Specific gravity
Base
Hardener
1.45
1.50

Standards and approvals

KingBond EP50PC complies with AASHTO M237, Type 2, slant shear, bond strength and gel time.

How to use

Surface preparation

All substrate surfaces should be clean and free of dust, lose material and contamination.

Mixing

One part of the base component should be mixed to one part of the hardener component. To avoid waste only mix sufficient quantities that can be used within the pot life. Components should be scooped from the tins and mixed together thoroughly using a spatula or palette knife in a suitable tin or board, until a uniform grey paste is obtained.

Application

The mixed adhesive is applied to both surfaces, then the two substrates are joint together within the mentioned pot life of the mixed adhesive.

Cleaning

Tools should be cleaned with KingKrete Solvent immediately after use. Hardened material can be removed mechanically.

Coverage, packaging and storage

Packaging

KingBond EP50PC is available in 5 and 20 kg Base component and 5 and 20 kg Hardener component.

THEORETICAL COVERAGE

3 - 3.5 kg/m² (mixed) @ 2 mm thickness.

POT LIFE

Pot life will vary depending on temperature and size of mix; extending at lower temperatures and smaller thickness of application. Pot life and set time given in table above were determined using a 200 g mix.

At temperatures above 25°C the material workability increases as does the rate of strength development. At temperatures lower than 25°C the material workability decreases and strength development slows.

Temperature (°C)Pot life (minutes)
2025 - 30
308 - 11

Storage

Shelf life is 1 year when stored under cover, out of direct sunlight and protected from extremes of temperature. Failure to comply with the recommended storage conditions may result in premature deterioration of the product or packaging. For specific storage advice consult KingKrete's Technical Services Department.

Health and safety

As with all chemical products, care should be taken during use and storage to avoid contact with eyes, mouth, skin and foodstuffs. Treat splashes to eyes and skin immediately. If accidentally ingested, seek medical attention. Reseal containers after use. Use in well ventilated areas and avoid inhalation.

Request the safety data sheet