🌍 🌐 English
Tile & Stone Adhesives and Grouts

KingFix AC25®

Ready to use tile adhesive

SpecWorld has the Spec Pack, CSI specification and drawings for registered specifiers.

Pot life
1.4 hrs.
Density
1.7 - 1.8

Overview

Ready to use tile adhesive, suitable for bonding all types of ceramic tiles to floors and walls.

Where to use

For permanent fixing of all types of tiles.

Can be used internally and externally.

Suitable for bathrooms and kitchens and wet areas.

Non sagging, can be used for walls and floors.

Suitable on MDF boards and gypsum boards.

Why use it

Water resistant, can be used in wet areas.

Ready for use, no need to add water.

Non sagging.

High bond strength.

Suitable for internal and external application.

Technical properties

Values @ 25°C

Shear adhesion
strength: EN12004
> 1 MPa
Open time20 – 30 mins.
Pot life1.4 hrs.
Tensile adhesion
strength: EN1348 : 1999
> 1.1 MPa
Density1.7 - 1.8

Standards and approvals

KingFix AC25 complies with EN 12004 D2.

How to use

Substrate preparation
  • All surfaces must be clean and free from oil, grease or loose materials.
  • Substrate should dimensionally stable. Allow time for shrinkage and structural strain movements.
Priming
  • KingFix AC25 can be applied directly on concrete, cement plaster, screed and cement or line mortar.
  • Prime gypsum boards with KingBond PVA50 diluted with water at a ratio of 1:2 by volume.
  • Spread to a uniform thickness of 2 - 3 mm.
  • Comb horizontally.
  • Place tiles firmly over the applied area.
  • Do not apply large areas of adhesives that cannot be covered within the open wet time of the adhesive.

Joints

Tiles should not be placed over expansion or contraction joints. Stop tiles on joint edges and fill joints with flexible sealant.

Cleaning

All tools should be cleaned immediately after finishing by water. Hardened materials can be cleaned mechanically.

Coverage, packaging and storage

Yield

Approximately 1.4 – 1.5 m²/ 5 kg @ 2 mm thickness.

Packaging

KingFix AC25 is available in 5 and 25 kg buckets.

Storage

Shelf life is 1 year when stored under cover, out of direct sunlight and protected from extremes of temperature.

Failure to comply with the recommended storage conditions may result in premature deterioration of the product or packaging. For specific storage advice consult KingKrete's Technical Services Department.

Health and safety

As with all chemical products, care should be taken during use and storage to avoid contact with eyes, mouth, skin and foodstuffs. Treat splashes to eyes and skin immediately. If accidentally ingested, seek medical attention. Reseal containers after use. Use in well ventilated areas and avoid inhalation.

Request the safety data sheet