🌍 🌐 English
Adhesives, Mortars & Plasters

KingFinish GY25®

Multi-purpose ready to use smooth finishing and putty plaster for internal applications.

SpecWorld has the Spec Pack, CSI specification and drawings for registered specifiers.

Density
1.7 ± 0.1 g/cm³
Solid content
70 ± 5%

Overview

KingFinish GY25 is an interior grade, ready to use smooth finishing and putty plaster for all common construction substrates including concrete surfaces, cementitious plaster, gypsum and plaster boards.

The unique composition of KingFinish GY25 makes it ideally suitable to provide an even and smooth surface ready for final paint application, filling hairline cracks as well as filling and finishing over gypsum and cement boards joints.

Where to use

KingFinish GY25 is designed for use internally in the following applications:

  • Fairing and smoothing concrete, cementitious plaster, wood, gypsum and plaster boards prior to applying finishing coats.
  • Filling hairline cracks in walls and ceiling as well as the minor damage in plaster work and nail holes in substrates.
  • Filling and levelling over gypsum and cement boards joints, fasteners and trim.

Why use it

  • Excellent adhesion to the substrates..
  • Easy to apply, ready to use single component.
  • Easy to smoothen after drying using fine sandpaper.
  • Excellent drying time.
  • Environmentally friendly, water based material.

Technical properties

Values @ 25°C

ColourWhite paste
Density1.7 ± 0.1 g/cm³
Solid content70 ± 5%
Tack-free time45 - 60 minutes @25˚C
VOCASTM D2369≤ 10 g/ltr
(Complies with LEED)

For filling the joints between gypsum and cement board, cover the joint with KingFinish GY25 using a proper stainless steel putty knife and then embed paper tape or glass fiber mesh while KingFinish GY25 is still wet. Allow drying then apply another layer of KingFinish GY25 over the joint and leave it to dry prior to sanding with fine sandpaper. If needed further coats can be applied to fill the joints completely, consider the drying time between each coat.

How to use

Method of use

Substrate preparation

All surfaces should be sound and clean from dust, oil and foreign matter. Ridges and trowel marks should be removed by abrasion. Surface should be dry before application.

Application

KingFinish GY25 shall be applied using a proper stainless steel putty knife or trowel to provide a smooth and level surface. Depending on the substrate condition, 2 - 3 coats of KingFinish GY25 should be applied before the finial finishing coat, Allow the first layer of KingFinish GY25 to dry prior to applying the next layer. The final layer should be lightly sanded using fine sandpaper before applying the finishing coat.

Coverage, packaging and storage

Coverage

Approximately 1.7 kg/m² at 1 mm thickness.

Packaging

KingFinish GY25 is available in 5 and 25 kg packages.

Storage

Shelf life is 1 year when stored under cover, out of direct sunlight and protected from extremes of temperature.

Failure to comply with the recommended storage conditions may result in premature deterioration of the product or packaging. For specific storage advice consult KingKrete's Technical Services Department.

Health and safety

As with all chemical products, care should be taken during use and storage to avoid contact with eyes, mouth, skin and foodstuffs. Treat splashes to eyes

and skin immediately. If accidentally ingested, seek

medical attention. Reseal containers after use. Use in well ventilated areas and avoid inhalation.

Request the safety data sheet