🌍 🌐 English
Adhesives, Mortars & Plasters

KingPlast R100®

Single component, pre-mixed dash slurry coat.

SpecWorld has the Spec Pack, CSI specification and drawings for registered specifiers.

Working time
100 mins.
Bulk density
1.5 ± 0.1 g/ cm³

Overview

KingPlast R100 is a polymer modified, ready to use cement based key coat, which when mixed with water produces a bonding agent layer between new plaster and fair face concrete.

Where to use

Key bonding agent between plaster and smooth substrates including blocks (normal and light weight), fair faced concrete and concrete with micro-silica.

Why use it

  • Very good bonding agent between cement based substrates and newly applied cement based plaster.
  • Easy to apply, single component, requires only addition of water.
  • Suitable for internal and external application.

Technical properties

ColourGrey
Bulk density1.5 ± 0.1 g/ cm³
Fresh wet density2.2 ± 0.1 g/ cm³
Maximum aggregate
size
3 mm
Open time15 mins.
Working time100 mins.
Initial set180 mins.
Final set24 hrs.

Standards and approvals

KingPlast R100 complies with ASTM C150, ASTM C897 and application standard ASTM C926.

How to use

Substrate preparation

Substrate must be clean and free from oil, grease, dust and laitance.

The substrate must be soaked with clean water before the application of KingPlast R100.

Mixing

To ensure proper mixing, a mechanically powered mixer or drill fitted with suitable paddle should be used.

3 liters of clean water should be mixed with 25 kg bag of KingPlast R100 to achieve the needed uniform consistency (and 6 liters for the 50 kg bag).

Application

Apply the KingPlast R100 using a tyrolean box or a power spray gun.

Curing

As KingPlast R100 is a cementitious based material, it should be cured in a similar manner to cement base materials. Soak the applied surfaces with water 2 - 3 times a day after setting.

Cleaning

All tools should be cleaned immediately after application using fresh water. Hardened materials must be cleaned mechanically.

Coverage, packaging and storage

Yield

5.9 kg/ m² for 3mm thicknesses. However, the consumption is depending on the application method and the substrate finish.

Packaging

KingPlast R100 is available in 25 kg and 50 kg bags.

Storage

Shelf life is 1 year when stored under cover, out of direct sunlight and protected from extremes of temperature.

Failure to comply with the recommended storage conditions may result in premature deterioration of the product or packaging. For specific storage advice consult KingKrete's Technical Services Department.

Health and safety

As with all chemical products, care should be taken during use and storage to avoid contact with eyes, mouth, skin and foodstuffs. Treat splashes to eyes and skin immediately. If accidentally ingested, seek medical attention. Reseal containers after use. Use in well ventilated areas and avoid inhalation.

Request the safety data sheet