KingMix 500ES®
High performance early strength concrete hyperplasticiser.
SpecWorld has the Spec Pack, CSI specification and drawings for registered specifiers.
Overview
KingMix 500ES is a high performance early strength concrete hyperplasticising admixture based on polycarboxylic polymers with long chains specially designed to enable the water content of the concrete to perform more effectively. This effect can be used in high strength concrete and flowable concrete mixes, to achieve highest concrete durability and performance.
Where to use
- Improved cohesion allowing for use in mass concrete pours and piling.
- Structures with congested reinforcement.
- High strength and high performance concrete.
- Pre-cast concrete.
- Concrete block.
- Self-compacting concrete.
- Coloured masonry products.
Why use it
- Higher early and ultimate compressive strengths.
- High density and impermeable concrete through extreme water reduction.
- Optimizes cement utilization.
- Minimizes segregation and bleeding problems by improving cohesion.
- Improves shrinkage and creep behaviors.
- Increases durability and resistance to aggressive atmospheric conditions thorough reduced permeability.
COMPATIBILITY
KingMix 500ES can be used with all types of Portland cement and cement replacement materials. KingMix 500ES should not be used in conjunction with other admixtures unless KINGKRETE technical department approval is obtained.
Technical properties
Values @ 25°C
| Colour | Light yellow liquid |
|---|---|
| Freezing point | ≈ -5°C |
| Specific gravity | 1.04 ± 0.02 |
| Air entrainment | Typically less than 2% additional air is entrained above control mix at normal dosages |
DOSAGE
The guidance dosage of KingMix 500ES is 0.4 to 4.0 litre per 100 kg of cementitious materials in the mix, including GGBFS, PFA or micro-silica.
Trials should be conducted to determine the optimum dosage of KingMix 500ES to meet the performance requirements by using the materials and conditions in actual use.
EFFECTS OF OVER DOSAGE
Over dosing of KingMix 500ES will cause the following:
- Significant increase in retardation.
Ultimate concrete strength will not be adversely affected and will generally be increased provided that proper concrete curing is maintained.
Standards and approvals
KingMix 500ES complies with ASTM C494 Type, F & E, depending on dosage used.
How to use
Method of use
KingMix 500ES should be added to the concrete with the mixing water to achieve optimum performance.
An automatic dispenser should be used to dispense the correct quantity of KingMix 500ES to the concrete mix.
Cleaning
KingMix 500ES can be washed with fresh cold water.
Coverage, packaging and storage
Packaging
KingMix 500ES is available in 25 litre pails, 210 litre drums and 1000 litre bulks supply.
Storage
Shelf life is 1 year when stored under cover, out of direct sunlight and protected from extremes of temperature.
Failure to comply with the recommended storage conditions may result in premature deterioration of the product or packaging. For specific storage advice consult KingKrete's Technical Services Department.
Health and safety
As with all chemical products, care should be taken during use and storage to avoid contact with eyes, mouth, skin and foodstuffs. Treat splashes to eyes and skin immediately. If accidentally ingested, seek medical attention. Reseal containers after use. Use in well ventilated areas and avoid inhalation